Mechanical Instructions
EN 15LC7.1HE LA 4.
4.3.10 Clock Board (optional)
1. Remove the rear cover, as described earlier.
2. Optionally remove the Main Supply panel, as described
earlier.
3. Optionally remove the Small Signal Board, as described
earlier.
4. Optionally remove the DC-DC converter for i-Board, as
described earlier.
5. Refer to fig. “Clock Board removal” below.
6. Disconnect the cable [1] on the Clock Board.
7. Now remove the sub-frame from the cabinet.
8. Remove the screws [2] that hold the Clock Board.
9. Lift the Clock Board from the set.
Figure 4-16 Clock Board removal
H_17150_116.ep
16080
1
2
To Next Page
Loading...
Need help?
General