26
English
IMPORTANT!
When in Eco Power standby mode, it is not
possible to show the clock time or set the
clock/timer function.
Clock setting
The clock can be set in either 12-hour or 24-hour mode
("12:00 AM" or "00:00", for example).
1 In standby mode, press CLOCK•TIMER once.
● While in the active source mode (DISC or TUNER, for
example), press CLOCK•TIMER twice.
2 Press PROG repeatedly to select clock mode.
➜ "12:00 AM" or "00:00" starts flashing.
3 Press S or T to set the hours and minutes. To
increase the speed, hold down S or T.
4 Press CLOCK•TIMER again to store the setting.
➜ The clock starts working.
To exit without storing the setting
● Press Ç on the system.
To view the clock time in other source mode
● Press CLOCK•TIMER.
➜ The clock is displayed for a few seconds.
➜ If the clock has not been set, "--:--" is displayed.
Notes:
– The clock setting will be cancelled when the power cord is
disconnected or if a power failure occurs.
– During clock setting, if no button is pressed within 90
seconds, the system will exit clock setting mode automatically.
Radio Reception Clock/Timer
RADIO RECEPTION / CLOCK/TIMER
ˇˇˇˇ
ˇˇ
»˚ preset numbers of all other preset radio stations in
the band with higher numbers also decrease by one.
● Repeat steps 1–2 to erase other preset radio stations.
To Next Page
