Philips MCD1060 - 6 Listen to Radio; Tune to a Radio Station; Program Radio Stations Automatically; Program Radio Stations Manually

15
English
EN
6 Listen to radio
Tune to a radio station
1 Press
FM
.
2 Press and hold / on the unit over
two seconds.
» [SEARCH]
(search) is displayed.
»
The radio tunes to a station with
strong reception automatically.
3 Repeat step 2 to tune to more stations.
 To tune to a weak station, press
/

reception.
 OK on
remote control repeatedly to select
stereo or mono sound.
Tip
 Position the antenna as far as possible from TV, VCR, or
other radiation source.
 For optimal reception, fully extend and adjust the
position of the antenna.
Program radio stations
automatically
You can program a maximum of 20 preset
radio stations (FM).
In FM mode, press and hold PROG/CLOCK
SET over two seconds to activate automatic
program mode.
» [AUTO] (auto) is displayed.
» All available stations are programmed.
» 
broadcast automatically.
Program radio stations
manually
Note
 You can program a maximum of 20 preset radio
stations.
1 Tune to a radio station.
2 Press
PROG/CLOCK SET
to activate
program mode.
» [PROG]
(program) begins to blink.
3 Press / to allocate a number (1 to 20)
to this radio station, and then press PROG/
CLOCK SET
4 Repeat the previous steps to program
other stations.
Note
 To overwrite a programmed station, store another
station in its place.
Select a preset radio station
In FM mode, press / to select a preset
number.
MCD1060_93_UM_V1.0.indb 15 2012-3-22 16:54:55