Philips MCD1060 - Set the Sleep Timer; Play from an External Device; Headphone

18 EN
To deactivate or re-activate an alarm timer
1 Press to switch to standby mode.
2 Press
TIMER/SLEEP
repeatedly to activate
or deactivate timer.
»
If timer is activated,
is displayed.
»
If timer is deactivated,
disappears.
Note
 In MP3 link mode, the timer cannot be set.
 If disc/USB source is selected and the audio cannot be
played, tuner is activated automatically.
Set the sleep timer
This unit can switch to standby automatically
after a set period of time.
When the unit is turned on, press TIMER/
SLEEP repeatedly to select a set period of time
(in minutes):
 [60 SLEEP]
 [45 SLEEP]
 [30 SLEEP]
 [15 SLEEP]
» When sleep timer is activated,
is
displayed.
To deactivate sleep timer
Press TIMER/SLEEP repeatedly until [OFF
SLEEP] (off sleep) is displayed.
» When sleep timer is deactivated,
disappears.
Play from an external device
You can also listen to an external audio device
through this unit.
1 Press MP3 LINK to select the MP3 link
source.
2 Connect an MP3 link cable to:
 the
MP3 LINK
connector (3.5mm) on
the unit.
 the headphone connector on an
external device.
3 Start to play the device (see user manual
of the device).
Headphone
Plug headphones (not supplied) into the
connector on the unit to listen through the
headphones.
MCD1060_93_UM_V1.0.indb 18 2012-3-22 16:55:00