Philips MCD170/98 - 6 Listen to Radio; Tune to a Radio Station; Program Radio Stations Automatically; Program Radio Stations Manually

20
Program radio stations
manually
Note
You can program a maximum of 40 preset radio •
stations.
1 Tune to a radio station.
2 Press PROG/ANGLE to activate program
mode.
[PROG] blinks on the display. »
3 Press / to allocate a number (1 to 40)
to this radio station, then press PROG/
ANGLE to confi rm.
The preset number and the frequency »
of the preset station are displayed.
4 Repeat the steps above to program other
stations.
Note
To overwrite a programmed station, store another •
station in its place.
Select a preset radio station
1 Press / to select a preset number.
Tip
Position the antenna as far as possible from TV, VCR •
or other radiation source.
For optimal reception, fully extend and adjust the •
position of the antenna.
6 Listen to radio
Tune to a radio station
1 Press TUNER repeatedly to select FM or
MW.
2 Press and hold / for more than 2
seconds.
[SEARCH] is displayed. »
The radio tunes to a station with »
strong reception automatically.
3 Repeat step 2 to tune to more stations.
To tune to a weak station, press •
/
repeatedly until you fi nd optimal
reception.
Program radio stations
automatically
Note
You can program a maximum of 40 preset radio •
stations.
1 In the tuner mode, press and hold
PROG/ANGLE for more than 2 seconds
to activate automatic program mode.
[AUTO] is displayed. »
All available stations are programmed »
in the order of waveband reception
strength.
The fi rst programmed radio station is »
broadcast automatically.
EN
MCD170_98_Eng.indd Sec1:20MCD170_98_Eng.indd Sec1:20 12/18/2008 2:27:47 PM12/18/2008 2:27:47 PM