Philips MCD177/98 - Volume Control; Sound Control; DBB (Dynamic Bass Boost); DSC (Digital Sound Control)

English
20
Volume control
Press VOLUME (or VOL +/- on the remote)
to increase or decrease the volume level.
➜ The display briefly shows ”VOL” and a volume
value from “01” to “31” ( “MIN” or “MAX” is
displayed when adjusted to the lowest or highest
volume level).
To switch off the volume temporarily
● Press MUTE on the remote.
➜ Playback will continue without sound and
“MUTE” appears.
● To activate sound reproduction, you can:
– press MUTE again;
– adjust the volume controls;
– change source.
Sound Control
DBB (Dynamic Bass Boost)
DBB enhances the bass response.
● Press breifly LOUD/DBB to enable or disable
DBB feature.
➜ If DBB is activated, “DBB” will be shown.
Helpful hints:
– Some discs might be recorded in high
modulation, which causes a distortion at high
volume. If this occurs, switch off DBB or reduce the
volume.
DSC (Digital Sound Control)
DSC provides a different type of preset sound
equalizer setting.
● Press DSC on the remote (or on the system)
repeatedly to select:
POP(default), CLASSIC, ROCK, JAZZ.
LOUDNESS
LOUDNESS feature enables the system to
automatically increase the treble and bass sound
effect at low volume (the higher the volume, the
lower the treble and bass increase).
● Press and hold LOUD/DBB on the remote
control to enable/disable LOUDNESS feature.
➜ icon appears/disappears after this feature
is enabled/disabled.
pg001-019_MCD177_98_Eng 3/3/08, 10:5820