32
English
Radio Reception
Tuning to radio stations
1 Press SOURCE on the set or TUNER on the
remote repeatedly until the desired waveband
(FM) is displayed.
2 Press and hold TUNING 22/33 and release
the button.
➜ The radio automatically tunes to a station
with sufficient reception.
3 Repeat step 2 if necessary until you find the
desired station.
● To tune to a weak station, press TUNING
22/33 briefly and repeatedly until you have
found optimal reception.
Programming radio stations
You can store up to a total of 40 radio stations
in the memory.
Automatic programming
Automatic programming will start with a chosen
preset number. From this preset number
upwards, former programmed radio stations will
be overridden.
1 Press PRESETí/ë to select the preset
number where programming should start.
Note:
– If no preset number is selected, default is preset
(1) and all your presets will be overridden.
2 Press PROG/ANGLE on the remote for more
than three seconds to activate programming.
➜ All available stations are programmed.
Manual programming
1 Tune to your desired station (refer to “Tuning to
radio stations”).
2 Press PROG/ANGLE to activate
programming.
➜ PROG flashes on the display.
3 Press PRESETí/ë to allocate a number
from 1 to 40 to this station.
4 Press PROG/ANGLE again to confirm the
setting.
➜ PROG disappears.
5 Repeat the four steps above to store other
stations.
● You can overwrite a preset station by storing
another frequency in its place.
Tuning to preset radio stations
● Press PRESETí/ë until the desired preset
station is displayed.
USB
pg001-pg041_MCD395-Eng 2010.4.2, 12:4732
To Next Page
Loading...
