Philips MCM1006 - Erase USB Programmed Tracks

10 EN
Program tracks
Note
•
You can program a maximum of 20 tracks.
• During programming, if no operation is made within
20 seconds, the system returns to stop mode without
saving programmed tracks.
1 Press to stop play.
» The total number of tracks is displayed.
2 Press PROG to activate the programming.
» PROG is displayed, and
blinks.
3 Press / (or ALBUM - /ALBUM +)
repeatedly to select an album.
» The album number and ALB blinks.
4 Press PROGagaintoconrmtheselected
album.
» A track number is displayed, and ALB
disappears.
5 Press / (or ALBUM - /ALBUM +)
repeatedly to select a track.
6 Press PROGagaintoconrmtheselected
track.
7 Repeat steps 3 to 6 to program more
tracks.
8 Press to start play.
Erase the program
To erase the program,
• Press
twice.
• Slide the power switch and source selector.