Philips MCM1006 - Play Discs; Control Disc Playback; Program Tracks

7EN
4 Play discs
1 Slide the power switch and source selector
to CD.
2 Lift the cover of disc compartment.
3 Load a disc with the printed side facing
upwards.
4 Close the cover of disc compartment.
» Play starts automatically after a few
seconds.
• If play does not start automatically,
press
to start play.
Control play
During play, follow the instructions below to
control play.
Buttons Function LCD
displays
Start or
resume play.
the track
number,
,
and
Pause play. the track
number,
, and
(blinking)
Stop play. the total
number
of tracks
and
/ Press to skip to
the previous or
next track.
the track
number,
,
and
/ Press and hold
to rewind or
search forward
fast within a
track.
the track
number,
,
and
ALBUM -
ALBUM +
Skip to the
previous or
next album
when no less
than one
album exists.
the track
number,
ALB, and
Program tracks
Note
•
You can program a maximum of 20 tracks.
• During programming, if no operation is made within
20 seconds, the system returns to stop mode without
saving programmed tracks.
For a CD
1 Press to stop play.
» The total number of tracks is displayed.
2 Press PROG to activate the programming.
» PROG is displayed, and
blinks.
3 Press / (or ALBUM - /ALBUM +)
to select a track.
» The track number blinks.
4 Press PROG again to program the selected
track.
5 Repeat steps 3 and 4 to program more
tracks.
6 Press to start play.
For a WMA/MP3 disc
1 Press to stop play.
» The total number of tracks is displayed.
2 Press PROG to activate the programming.
» PROG is displayed, and
blinks.
3 Press / (or ALBUM - /ALBUM +)
repeatedly to select an album.
» The album number and ALB blinks.
4 Press PROGagaintoconrmtheselected
album.
» A track number is displayed, and ALB
disappears.
5 Press / (or ALBUM - /ALBUM +)
repeatedly to select a track.