14
English
CD/MP3-CD Operations
IMPORTANT!
The lens of the CD player should never be
touched.
X
Discs for playback
This system is able to play :
– All pre-recorded audio CDs
– All finalised audio CDR and audio
CDRW discs
– MP3-CDs (CD-ROMs with MP3 tracks)
● CD-ROM, CD-I, CDV, VCD, DVD or computer
CDs, however, are not possible.
Playing a disc
1 Select CD source.
2 Press OPEN/CLOSEç to open the CD
compartment.
➜ “CD OPEN” is displayed.
3 Insert a disc with the printed side facing up and
press OPEN/CLOSEç to close the CD door.
➜ “READING” is displayed as the CD player
scans the contents of a disc, and then the total
number of tracks and playing time (or the total
number of albums and tracks for MP3 disk) are
shown.
4 Press ÉÅ to start playback.
To interrupt playback
● Press ÉÅ.
● To resume playback, press ÉÅ again.
To stop playback
● Press Ç.
Notes:
– Disc play will also stop when you select another
source or the disc has reached the end.
–For MP3 disc, the disc reading time may exceed
10 seconds due to the large number of songs
compiled into one disc.
Te xt display
In CD mode
● Press BAND/DISPLAY (or DISPLAYon the
remote control) repeatedly to see the following
information.
➜ Track number and elapsed play time of
current track.
➜ Remaining play time of current track.
➜ Total number of tracks played and total
elapsed time.
➜ Total remaining number of tracks and total
remaining play time.
In MP3-CD mode
● Press BAND/DISPLAY (or DISPLAYon the
remote control) repeatedly to select four display
modes : Number, Track, Album and ID3.
Number ➜ The current album and track
numbers are displyed briefly.
Track ➜ The current track name scrolls twice.
Album ➜ The current album name scrolls twice.
ID-3 ➜ The ID-3 tag scrolls twice.
Selecting a different track
● Press TUNING S/T (S/T on the
remote control) repeatedly until the desired
track number appears in the display.
● If playback is stopped, pressÉÅ to start
playback.
pg 001-024_MCM726_22_Eng 3/20/07, 5:55 AM14
To Next Page
Loading...
