16
English
Radio Reception
Tuning to radio stations
1 Select TUNER source.
➜ “TUNER” is displayed briefly.
2 Press BAND/DISPLAY (or TUNER on the
remote control) to select the desired waveband :
FM, MW or LW.
3 Press down on TUNING S/T (S/T
on the remote control) and release the button.
➜ The display will show "SEARCH" until a radio
station with sufficient signal strength is found.
➜ If a FM station is received in stereo, is
shown.
4 Repeat step 3 if necessary until you find the
desired station.
● To tune to a weak station, press TUNING
S/T (S/T on the remote control)
briefly and repeatedly until you have found
optimal reception.
Programming radio stations
You can store up to 40 radio stations in the
memory.
Automatic programming
Automatic programming will start with a chosen
preset number. From this preset number
upwards, former programmed radio stations will
be overridden.
1 Press ALBUM/PRESET 4/3 to select the
preset number where programming should start.
Note:
– If no preset number is selected, default is preset
(1) and all your presets will be overridden.
2 Press PROGRAM for more than two seconds
to activate programming.
➜ All available stations are programmed.
Manual programming
1 Tune to your desired station (refer to “Tuning to
radio stations”).
2 Press PROGRAM to activate programming.
➜ PROG flashes in the display.
3 Press ALBUM/PRESET 4/3 to allocate a
number from 1 to 40 to this station.
4 Press PROGRAM again to confirm the setting.
➜ PROG disappears, the preset number and
the frequency of the preset station are shown.
5 Repeat the above four steps to store other
stations.
● You can override a preset station by storing
another frequency in its place.
pg 001-024_MCM726_22_Eng 3/20/07, 5:55 AM16
To Next Page
Loading...
