English
13
Installation
Using AC power
1 Make sure all the connections have been made
before switching on the power supply
2 Connect the AC power cord to the wall socket.
This switches on the power supply
➜ AUTO INSTALL – PRESS PLAY appears
the first time you power up MCM760
– Press ÉÅ on the set to store all available
radio stations
– Press Ç to exit (See Tuner)
Helpful hints:
– If the first preset is a RDS station, it will proceed
to clock setting (See Tuner: Clock setting via
RDS)
➜ "INSTALL" appears, then "TIME" and
"SEARCH RDS TIME".
➜ When RDS time is read, " RDS TIME" will
appear and the current time will be stored.
➜ If RDS station does not transmit RDS time
within 90 seconds, “NO RDS TIME” will appear
and the program will exit automatically.
CAUTION
Visible and invisible laser radiation. If the
cover is open, do not look at the beam.
High voltage! Do not open. You run the risk
of getting an electric shock.
The machine does not contain any user-
serviceable parts.
Modification of the product could result in
hazardous radiation of EMC or other
unsafe operation.
If you disconnect the product from the
mains, make sure to take the plug out of
the wall socket completely.
Children could seriously injure themselves
as the free end of the cable may still be live
if only the connector is removed from the
MAINS socket at the back of the unit.
3 Select AUX mode on MCM760
Helpful hints:
– Always refer to the owner’s manual of other
equipment for complete connection.
When MCM760 is switched to standby, it is still
consuming some power. To disconnect the
system from the power supply completely,
remove the power plug from the wall
socket.
The type plate is located on the rear of the
set.
001-033_MCM760_12_Eng 3/29/06, 12:48 PM13
To Next Page
Loading...
