Philips MCM761/61 - Programming Tracks; Erasing the Program

18
English
CD
Programming tracks
You may store up to 99 tracks in the desired
sequence. If you like, store any track more than
once.
1 In the stop position, press PROGRAM (on the
remote control) to start programming
➜ PROG flashes
➜ Audio CD: Display shows current
track number
MP3/WMA: Display shows current album/
track number
2 Press í or ë once or repeatedly until the
desired track number appears in the display
● MP3/WMA: Press à / á and í / ë to
select the desired album and track
3 Press PROGRAM to confirm
➜ Audio CD: Display shows briefly the
number and playing time of tracks programmed;
Then, the display shows PROG and the track
number you just stored
➜ MP3/WMA: Display shows briefly the
number of tracks programmed;
Then, the display shows the album/ track number
you just stored
Helpful hints:
– The set will return to the stop position if no
button is pressed within 20 seconds.
PROG stops flashing. To resume programming, press
PROGRAM.
Erasing the program
You can erase the contents of the memory by:
● Press 9
– once if in the stop position (after you stop
programming);
– twice during playback;
● Press STANDBY-ON/ECO POWER y
● Select another sound source
● Open the CD door
➜ PROG disappears. PROGRAM CLEARED
scrolls
4 Repeat steps 2-3 to select and store all desired
tracks.
➜ PROGRAM FULL is displayed if you attempt
to program more than 99 tracks
5 Press Ç to stop programming
➜ PROG stops flashing
➜ Audio CD: Display shows the number and
playing time of tracks programmed
➜ MP3/WMA: Display shows the album/ track
number you just stored
6 Press ÉÅ play the program
CD TUNER
REPEAT PROGRAM
TAPE A /B DISPLAY/CLOCK
SHUFFLE
TAPE AUX
STANDBY
DISC
CD
PROG
DISC
MP3
CD
PROG
DISC
CD
PROG
DISC
CD
PROG
p001-032_MCM761_61_Eng 2008.6.26, 10:4418