Philips MCM761/61 - Tuner; Tuning to Radio Stations; Programming Radio Stations; Plug & Play

20
English
Tuner
Tuning to radio stations
1
Press TUNER to select TUNER source
2 Press TUNER repeatedly to select your desired
waveband, FM or MW
➜ Display shows: , radio station
frequency, waveband and if programmed, a
preset number
3 Press and hold à or á until SEARCH
appears
➜ The radio automatically tunes to a station
with sufficient reception. Display shows SEARCH
during automatic tuning
➜ FM: If a station is received in stereo, is
shown
4 Repeat step 3 if necessary until you find the
desired station.
● To tune to a weak station, press à or á
briefly and repeatedly until you have found
optimal reception
Plug & Play
1 Connect the system to the power supply
➜ "AUTO INSTALL – PRESS PLAY" appears.
Or
In Eco Power standby/standby mode,
press and hold ÉÅ on the set until "AUTO
INSTALL – PRESS PLAY" appears
2 Press ÉÅ on the set to start installation
➜ "INSTALL TUNER AUTO" appears
➜ All previously stored radio stations will be
replaced
➜ After all stations are stored, the last preset
station will then be played
Plug & Play allows you to store all available radio
stations automatically.
Programming radio stations
You can store up to a total of 40 radio stations
(FM and MW) in the memory, manually or
automatically (Autostore).
CD TUNER
REPEAT PROGRAM
TAPE A / B DISPLAY/CLOCK
SHUFFLE
TAPE AUX
STANDBY
TAPE REC USB REC USB DEL SNOOZE
PRESET
ALBUM
VOL
TUNER
TUNER
FM
OPEN • CLOSE
ALBUM/ PRESET STOP/ DEMO
VOLUME
BASS
TREBLE
PLAY/PAUSETUNING
WMA
-
MP3
-
CD/CD
-
R/CD
-
RW COMPATIBLE
p001-032_MCM761_61_Eng 2008.6.26, 10:4420