21
English
Manual programming
1 Tune to your desired station (see Tuning to
radio stations)
2 Press PROGRAM (on the remote control) to
activate programming
➜ The preset number starts flashing
3 Press í or ë to allocate a number from 1 to
40 to this station
4 Press PROGRAM (on the remote control) to
confirm
➜ Display shows the preset number, waveband
and the frequency of the preset station
5 Repeat steps 1-4 to store other stations
● You can erase a preset station by
storing another frequency in its place
Tuner
Autostore: Automatic programming
Automatic programming will start from preset 1
or a chosen preset number. From this preset
number upwards, former programmed tuner
stations will be erased. The set will only program
stations which are not in the memory already.
1 Press the í or ë buttons once or more to
select the preset number where programming
should start.
Note:
– If no tuner preset number is selected, default is
preset 1 and all your presets will be erased.
2 Press and hold PROGRAM (on the remote
control) until AUTO appears
➜ PROG flashes
➜ Available stations are programmed:
FM stations followed by MW stations
➜ After all stations are stored, the last preset
station will then be played
To listen to a preset station
● Press the í or ë buttons once or more until
the desired preset station is displayed
Deleting a preset radio station
● Press and hold Çuntil “ PRESET DELETED”
appears.
➜ The current preset radio station will be
deleted
➜ The preset radio stations behind it move
forward by one number
CD TUNER
REPEAT PROGRAM
SHUFFLE
TAPE AUX
STANDBY
p001-032_MCM761_61_Eng 2008.6.26, 10:4421
To Next Page
Loading...
