Installation and Initial Checks
MCP9350i 7. EN 13
10. Check the power values. (BIOS menu select: Advanced > Hardware Monitoring). See table below.
Power Center value (allow for a ± 5% variation)
V 12.0 +12.0 V (± 0.6 V)
V 5.0 +5.0 V (± 0.25 V)
V 3.3 + 3.3 V (± 0.165 V)
V 1.5 +1.5 V (± 0.075 V)
V ccp + 1.28 V (± 0.064 V)
11. Exit the BIOS setup screen without saving changes. (BIOS menu select: Exit > Exit discarding changes).
The MCP9350i will now continue to start-up. Perform the start-up sequence check, see paragraph 7.3.
7.2.2. Fail Procedure
Perform Troubleshooting procedure. See paragraph 8.
To Next Page
Loading...
