Philips MCP9350i - End Test

End Test
MCP9350i 14. EN 65
14. End Test
Before the set can be returned to the customer an end test must be performed. Run the automatic test batch file in PC Doctor. See
paragraph 10.3.
• For sets where a software and/or hardware repair has been done run the script once. The test will take approximately 15 minutes.
• For sets where no repair has been done a check must be made for intermittent faults. In PC Doctor, make sure that the script is
repeated 8 times. See Figure 14-1. The test will take approximately 2 hours.
Figure 14-1