Software Update and Repair
MCP9350i 9. EN 19
9.5. System Recovery
A system restore is used to return the set to its original software configuration. If a later software built is available, this built should be
installed on the system instead (see Chapter 13 – Software Re-installation)
1. In Windows XP select: Start > All programs > System Recovery > System Recovery. (Alternatively, press the F11 key during
boot sequence).
Figure 9.5-1
2. Follow the on-screen instructions to perform a system recovery without performing a format, (operations from this point are carried
out in DOS mode).
Figure 9.5-2
To Next Page
Loading...
