Philips MCP9350i - Page 24

EN 24 11. MCP9350i
Hardware Tests
11.3. System Fans
11.3.1. Required Equipment
None.
11.3.2. Test Procedure
At first start-up, the PSU and CPU fans will start at the highest speed. After a couple of seconds, the fans must switch to a slower speed.
Note: When the system has already been running, the fans might start at the lower speed.
11.3.3. Fail Procedure
- Replace the PSU fan. See paragraph 12.14.3.
- Replace the CPU fan. See paragraph 12.15.5.
- Replace the motherboard. See paragraph 12.16.9.
11.4. CPU
11.4.1. Required Equipment
PC Doctor CD & USB dongle
11.4.2. Test Procedure
In PC Doctor: Run the CPU test.
11.4.3. Fail Procedure
Replace the CPU. See paragraph 12.16.5.
11.5. HDD (Hard disk drive)
11.5.1. Required Equipment
PC Doctor CD & USB dongle
11.5.2. Test Procedure
In PC Doctor: Run the ‘SMART’ test.
11.5.3. Fail Procedure
- Replace the SATA cable.
- Replace the HDD. See paragraph 12.3.
- Make sure that the latest software image is installed on the replacement HDD. See paragraph 13.
11.6. Card Reader
11.6.1. Required Equipment
• PC Doctor CD & USB dongle
• Compact Flash (CF) card
• Smart Media (SM) card
• Secure Digital (SD) card
• Memory Stick (MS)
11.6.2. Test Procedure
1.
Insert the memory cards into the appropriate slots of the card reader.
2.
In PC Doctor: Run the card reader test.
11.6.3. Fail Procedure
- Replace the V-Type cable.
- Replace the card reader board. See paragraph 12.11.3.
- Replace the motherboard. See paragraph 12.16.9.