Philips MCP9350i - Page 60

EN 60 12. MCP9350i
Hardware Repair
Figure 12.16-5
Figure 12.16-6
12.16.2. Motherboard Subassembly Re-Assembly
To re-assemble the motherboard subassembly, do all processes described in paragraph 12.16.1 in reverse order.
Note:
The torque setting required for the motherboard subassembly mounting screws (12) is 8kg-cm
The torque setting required for the AC input mounting screws (11) is 6kg-cm
Note: Remove and re-apply fresh thermal transfer compound between the CPU and the heat sink.
12.16.3. SCART Daughterboard Removal
1. Remove the motherboard subassembly. See paragraph 12.16.1.
2. Disconnect the ADD2 SCART cable (14) from the motherboard. See Figure 12.16-7.
3. Disconnect the ADD2 SCART cable (15) from the SCART daughterboard. See Figure 12.16-7.
4. Remove the 2 mounting screws (16) from the SCART daughterboard. See Figure 12.16-7.
5. Remove the 2 mounting screws (17) from the SCART connector. See Figure 12.16-8.
6. Remove the SCART daughterboard from the chassis.
Figure 12.16-7 Figure 12.16-8
12.16.4. SCART Daughterboard Re-Assembly
To re-assemble the SCART daughterboard, do all processes described in paragraph 12.16.3 in reverse order.
Note: The torque setting required for the SCART connector mounting screws (17) is 4kg-cm
The torque setting required for the SCART daughterboard mounting screws (16) is 6kg-cm
12
12
13
16
16
15
14
17
17