English
55
3 Press the length selector and then push it to
the left or right to select the desired hair length
setting.
4 Switch on the appliance.
5 Move the appliance upwards while you exert
gentle pressure. Make sure the front of the comb
is in full contact with the skin.
6 Switch o the appliance and clean the attachment
after use.
Using the beard styler attachment without
comb
You can use the beard styler attachment without the
comb to contour your beard, moustache, sideburns or
neckline to a length of 0.5mm.
1 Pull the comb o the beard styler attachment.
Note: Grab the comb in the center to pull it o the
beard styler attachment. Do not pull at the sides
of the comb.
2 Switch on the appliance.
3 Hold the beard styler attachment perpendicular
to the skin and move the appliance downwards
while you exert gentle pressure.
4 Switch o the appliance and clean the attachment
after use.
Storage
Note: We advise you to let the appliance and its
attachments dry before you store them for the next
use.
- Store the appliance in the pouch (if supplied).
- Put the protection cap (if supplied) on the shaver
to protect it from dirt accumulation.
- Alternatively, store the appliance on the charging
To Next Page
Loading...
