English
57
4 Press the small circular piece on the handle of the
Quick Clean Pod Cartridge to break the snap hook
on the handle.
5 Place the Quick Clean Pod Cartridge into the Quick
Clean Pod.
6 Put the top of the Quick Clean Pod back onto the
base and turn it clockwise until you hear a click.
Do not tilt the Quick Clean Pod to prevent leakage.
Using the Quick Clean Pod
Note: If you use the shaver with shaving foam,
shaving gel or pre-shave products, thoroughly rinse
the shaving heads before you use the Quick Clean
Pod (see 'How do I clean my appliance and the
attachments?').
Always shake excess water o the shaver before
you place it in the Quick Clean Pod.
1 Place the shaver upside down into the Quick Clean
Pod. While switched on, the shaver automatically
detects that it is in the Quick Clean Pod.
2 Switch on the shaver to start the cleaning
program.
Each cleaning program takes approximately
one minute. During the cleaning program the
remaining time is displayed as a countdown clock
on the handle.
To Next Page
Loading...
