Pressure sensor
Your Philips Sonicare is equipped with an
advanced sensor that measures the pressure you
apply while brushing. If you apply too much
pressure, the toothbrush will provide immediate
feedback to indicate that you need to reduce the
pressure. This feedback is given by a change in
vibration and therefore brushing sensation.
To deactivate the pressure sensor see 'Activating
or deactivating features'.
Quadpacer
The Quadpacer is an interval timer that has a short
beep and pause to remind you to brush the
different sections of your mouth.
Activating or deactivating features
You can activate or deactivate the following
features of your toothbrush:
- EasyStart
- Brush head replacement reminder
- Pressure sensor
To activate or deactivate these features, follow the
instructions below:
EasyStart
1 Put the handle on the plugged-in charger.
2 Press and hold the power on/off button while
the handle remains on the charger.
3 Keep the power on/off button pressed until you
hear a single short beep (after 2 seconds).
4 Release the power on/off button.
16
English
To Next Page
Loading...
