2 Press and hold the power on/off button while
the handle remains on the charger.
3 Keep the power on/off button pressed until you
hear a series of three short beeps (after 6-7
seconds).
4 Release the power on/off button.
-
Triple tone of low-med-high means the
pressure sensor feature has been activated.
The brush head replacement light and
battery light will also blink green 2 times in
unison to confirm activation.
-
Triple tone of high-med-low means the
pressure sensor feature has been
deactivated. The brush head replacement
light and battery light will also blink amber 1
time in unison to confirm deactivation.
If you continue holding the power on/off button
after the three short beeps, the
activate/deactivate sequence repeats.
Battery status and charging
1 Put the plug of the charger in an electrical
outlet.
2 Place the handle on the charger.
-
The charger will emit 2 short beeps to
confirm that the handle is placed properly.
-
The flashing light of the battery level
indicator shows that the toothbrush is
charging.
-
When handle is fully charged on the charger,
the battery light shows solid green for 30
seconds and switches off.
Note: Your toothbrush comes pre-charged for first
use. After first use, charge for at least 24 hours.
18
English
To Next Page
Loading...
