Philips SRP5004 - Page 13

13EN
English
How do I set the remote control for combo devices (TV /
VCR, TV / DVD, DVD / VCR, etc)?
Some combo devices require you to set up two different
source selection keys to control both parts of the combo
device. For example, if you have a TV / DVD combo, you
might need to set up the remote control for both TV and
DVD to operate your TV / DVD combo.
Operation
The remote control does not wake up anymore.
Battery level too low or battery lifetime came to an end.
• Replacethebatteries.Seechapter2.1.
The device I want to operate does not respond at all /
does not respond to all of the key commands.
• Checkifthekeysyoupressareavailableontheoriginal
remote control of the device.
• Tryimproving
keys . See chapter 2.3.2.
Not all key functions are available in the database of the
remote control.
• Trylearningkeyfunctionsfromtheoriginalremote
control. See chapter
3.2.
Wrong code selected during setup.
• Setuptheremotecontrolagainforthedevice.Always
test if the device responds, before leaving setup mode.
See chapter 2.2.
It may be that the keys that you are trying to use have a
different naming on the original remote control.
• Tryoutallkeystofindtheone(s)youneed.
The Teletext keys do not work.
• FindoutwhetheryourTVisequippedwithTeletext.
• TryimprovingtheTeletext
keys . See chapter 2.3.2.
• Checkwhetheryouareusingthecorrectkeystoswitch
on Teletext. For TV this is the
key; for STB this is the
k ey.
Batteries
Will my settings be deleted when I replace the batteries?
No.
All user settings will be retained in the remote control
memory during battery replacement.
Service and support
SRP5004_86_Manual_Def.indd 13 01-06-09 12:34