Philips SRP5004 - Using the Universal Remote; Remote Control Keys and Functions Overview

8 EN
2 Select the device you wish
to operate (e.g. DVD).
Press the device
selection key to select DVD.
3 Keep keys and
pressed simultaneously for
5 seconds.
 • The red Setup LED
lights up. The remote
control is now in setup
mode.
4 Press and hold the key that does not function and
immediately release it when the device responds.
• Ifthekeystilldoesnotfunctionasexpected,try
pressing it again for a longer period of time.
5 Press the device
selection key twice to save
your settings and exit setup
mode.
 •
When no key is
pressed for 5 minutes
or more, the remote control will exit setup mode,
automatically saving all your settings.
3 Using the universal remote
control
3.1 Keys and functions
The illustration on page 2 gives an overview of all keys on
the remote control. Try out the keys you need for operating
your devices.
Notes
• Keys having the same functions as the keys on your
original remote control may have different namings
on the SRP5004 (e.g. Info / Display).
• Only functions that are available on your original
remote control can be used for operating your
devices with the SRP5004.
5 sec.
2 x
SRP5004_86_Manual_Def.indd 8 01-06-09 12:34