Philips SRP5004 - Service and Support; Frequently Asked Questions and Getting Help

12 EN
3.3 Resetting a key to its original function
When resetting a key to its original function, any learned
function stored under the key will be deleted.
1 In the current device
mode, keep digit keys
and
pressed
simultaneously for 5 seconds,
until the red Setup LED
lights up.
 • Theremotecontrolisnowinsetupmode.
2 Press digit keys , ,
and , in that order.
 • Aftereachkeypress
the device selection key
blinks once.
3 Press the key you wish to
reset twice. E.g. the 22 key.
 • Aftereachkeypress
the device selection key
blinks once.
 • Thedeviceselectionkey
will blink one more time to confirm that the key was
succesfully reset to its original function.
 • Thekeycannowalsolearnanewfunction,ifdesired.
4 Service and support
4.1 Frequently asked questions
In this chapter you will find answers to the most frequently
asked questions about your universal remote control.
Setup
I cannot enter setup mode.
Battery level too low or battery lifetime came to an end.
• Replacethebatteries.Forthisseechapter2.1.
5 sec.
2 x
SRP5004_86_Manual_Def.indd 12 01-06-09 12:34