6
When the tape has finished rewinding, press the EJECT
button to remove the tape.
4
Press the STOP button to stop playback.
5
Press the REWIND button to rewind the tape.
Playing 23
Read and follow the steps below to play a tape.
1
Turn on the TV and set it to channel 3 or 4, whichever
channel the CH3/CH4 switch on the back of the VCRis set to.
2
Insert a tape in the VCR. The POWER and CST.IN lights will
appear. If the tape’s record tab has been removed, the VCR/TV
light will appear and playback will begin automatically.
3
If playback does not start automatically, press the
VCR/TV button to put the VCR in VCR position (the
VCR/TV light will appear). Then, press the PLAY button.
Turn on the TV.
Insert a tape.
3
1
2
• If the tape you want to play is
already in the VCR, make sure the
VCR power is on and the VCR is in
VCR position. (Press the VCR/TV
button so that the VCR/TV light
appears.) Then, press the PLAYbut-
ton.
• Other playback options and fea-
tures are on pages 34 - 41.
Helpful Hints
6
4
5
SVZ142.comb 4/7/99 6:30 PM Page 23
To Next Page
Loading...
