EasyManua.ls Logo

Philips TAR3205 - Product Information; Troubleshooting

Philips TAR3205
10 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
7
EN
6 Product
information
Note
Product information is subject to change without prior notice.
Amplier
Rated Output Power 200mW RMS
Tuner (FM)
Tuning Range 87.5-108 MHz
Tuning Grid 50 KHz
Sensitivity
- Mono, 26 dB S/N Ratio
<22 dBf
Total Harmonic Distortion <3%
Signal to Noise Ratio >50 dBA
General information
AC Power (power
adaptor)
Brand: Philips;
Model: AS030-050-EE060
Input: 100-240V~
50/60 Hz; 0.15A
Output: 5V 0.6A
Operation Power
Consumption
<3 W
Standby Power
Consumption
<1 W
Dimensions
(W x H x D)
131 x 54 x 131 mm
Weight
(Main unit)
198.9 g
7 T
roubleshooting
Warning
Never remove the casing of the product
To keep the warranty valid, never try to repair
the device yourself.
If you encounter problems when using this
device, check the following points before
requesting service. If the problem remains
unsolved, go to the Philips webpage (ww.philips.
com/support). When you contact Philips, make
sure that the device is nearby and the model
number and serial number are available.
No power
Make sure that the AC power plug of the unit
is connected properly.
Make sure that there is power at the AC outlet.
No sound
Adjust the volume.
No response from the unit
Disconnect and reconnect the AC power
plug, then turn on the unit again.
Poor radio reception
Keep the clock radio away from other
electronic devices to avoid radio interference.
Fully extend and adjust the position of the antenna.
Alarm does not work
Set the clock/alarm correctly.
Clock/alarm setting erased
Power has been interrupted or the power
plug has been disconnected.
Reset the clock/alarm.

Related product manuals