Go to cover page
4) Press the or button to move the image up or down.
5) When the position is adjusted, press the button to return to
MAIN CONTROLS window, or press the button to highlight
ADJUST SIZE.
6) To adjust the vertical size, press the or button.
7) When the size is adjusted, press the button to return to MAIN
CONTROLS window. CLOSE MAIN CONTROLS will be highlighted.
Smart Help After returning to MAIN CONTROLS...
... To continue to ADJUST SHAPE, press the button until ADJUST
SHAPE is highlighted. Next, start with step under ADJUST SHAPE and
follow the directions.
... To exit completely, press the button.
ADJUST SIDE CURVE
ADJUST SIDE CURVE under ADJUST SHAPE allows you to adjust two
of the five preset options. These two options are PINCUSHION and
BALANCED pincushion. Note: use these features only when the picture
is not square.
1) Press the button on the monitor. The MAIN CONTROLS window
appears.
2) Press the button until ADJUST SHAPE is highlighted.
3) Press the button. The ADJUST SHAPE window appears.
ADJUST SIDE CURVE should be highlighted.
ADJUST SHAPE
4) Press the button. The SIDE CURVE window appears.
PINCUSHION should be highlighted.
5) To adjust the pincushion, press the or button, then
press the button to save your selection.
6) When the pincushion is adjusted, press the button to
highlight BALANCE or press the button to return to the
ADJUST SHAPE window.
7) To adjust the balanced, press the or button.
8) When the balanced is adjusted, press the button. BACK TO
ADJUST SHAPE will be highlighted.
9) Press the button to return to the ADJUST SHAPE window, then
press the button until ADJUST SIDE ANGLES is highlighted.
Smart Help After returning to MAIN CONTROLS...
... To continue to ADJUST SIDE ANGLES, start with step 5 under
ADJUST SIDE ANGLES and follow the directions.
...To exit completely. Press the button twice.
ADJUST SIDE ANGLES under ADJUST SHAPE allows you to adjust
two of the five preset options. These two options are TRAPEZOID
and PARALLELOGRAM. Note: use these features only when the
picture is not square.
1) Press the button on the monitor. The MAIN CONTROLS
window appears.
2) Press the button until ADJUST SHAPE is highlighted.
ADJUST SIDE ANGLES
To Next Page
Loading...
