OSD Adjustments (Continued)
109B6 CRT
Go to cover page
11
3) Press the button. The ADJUST SHAPE window appears.
ADJUST SIDE CURVE should be highlighted.
4) Press the button to highlight ADJUST SIDE ANGLES.
5) Press the button. The SIDE ANGLES window appears.
TRAPEZOID should be highlighted.
6) To adjust the trapezoid, press the or button, then
press the button to save your selection.
7) When the trapezoid is adjusted, press the button to
highlight PARALLELOGRAM or press the button to return
to the ADJUST SHAPE window.
8) To adjust the PARALLELOGRAM, press the or button.
9) When the parallelogram is adjusted, press the button to return
to the ADJUST SHAPE window. BACK TO MAIN CONTROLS window
will be highlighted.
10) Press the button to return to the MAIN CONTROLS window, or
press the button until ROTATE IMAGE is highlighted.
Smart Help After returning to MAIN CONTROLS...
... To continue to ROTATE IMAGE, start with step 5 under ROTATE IMAGE
and follow the directions.
...To exit a completely, press the button twice.
...To adjust only the PARALLELOGRAM, follow steps 1-4 above, then
press the button, and follow steps 7-9
ROTATE IMAGE under ADJUST SHAPE allows you to adjust the rotated
image. Note : use this feature only when the picture is not square.
1) Press the button on the monitor. The MAIN CONTROLS window
appears.
2) Press the button until ADJUST SHAPE is highlighted.
ROTATE IMAGE
3) Press the button. The ADJUST SHAPE window appears.
ADJUST SIDE CURVE should be highlighted.
4) Press the button until ROTATE IMAGE is highlighted.
5) Press the button. The ROTATE IMAGE window appears.
ROTATE will be highlighted.
6) To adjust the rotation, press the or button.
To Next Page
Loading...
