Philips WelcomeEye Connect DES9900VDP - 531002 - Safety Precautions

WelcomeEye Connect / Touch / 08/17
GB12
9. SAFETY PRECAUTIONS:
Any damage caused by a failure to adhere to the manual shall void the warranty. We assume
no liability for damages resulting therefrom!
We cannot be held responsible for any damage to property or persons caused by incorrect
use or a failure to adhere to the safety instructions.
This product has been manufactured in full compliance with safety instructions. In order to
maintain this status and get the most out of the product, users must adhere to the safety
instructions and warnings contained in this manual.
: This symbol indicates that there is a risk of electric shock or short-circuit.
- You should only use this product with a voltage between: 100-240 Volts and 50-60 hertz.
Never attempt to use this device with a dierent voltage.
- Ensure that all the system’s electrical connections conform to the instructions for use.
- In commercial establishments, ensure that you adhere to the electrical installation
accident prevention regulations.
- In schools, training facilities, workshops, etc. qualied personnel must be on hand to
monitor electronic equipment operation.
- You must follow the instructions for use of any other devices connected to the system.
- Please contact an experienced person if you have any doubts regarding equipment
operation or safety.
- Never plug in or unplug electrical equipment with wet hands.
- When installing this product, check that the power supply cables are not at risk of being
damaged.
- Never replace damaged electrical cables yourself! In this case, remove them and call an
expert.
- The mains supply should be located close to the device and must be easily accessible.
- A switching device (a switch disconnecter, circuit breaker or equivalent device) must be
easily accessible and integrated into the installation of the building wiring for equipment
which is permanently connected to the network.
- To ensure the device has sucient ventilation, keep the area around the device
unobstructed.
- Ventilation should not be blocked by covering the ventilation opening with an object such
as a newspaper, tablecloth or curtain, etc).
- No open ame sources, such as lit candles, should be placed on the device.
- Comply with the product’s operating temperature.
- The device should not be exposed to running or splashing liquid and no object lled with
liquid should be placed on the device.