Philips WelcomeEye Link 531034 - Creating Scenarios and Automations

WelcomeEye / Link / V1
F19
(Next).
Name the group, then conrm by pressing “Créer” (Create).
D - To add a scenario, you must set: a trigger, an action and a triggered element.
Up to 10 scenarios can be programmed.
The example shows a Philips Hue light bulb turning on whenever a visitor rings the LINK
videophone intercom.
Note: before programming a scenario, all devices must be registered to and operating
from the Philips WelcomeHome application (see Chapter 9. COMPATIBLE PRODUCTS).
Press “Ajouter une action” (Add action), “Appareil” (Device), and then select the room
where the device to be controlled is located. Conrm your device.
Choose the action you want the device to perform, then press “Suivant” (Next)