EasyManua.ls Logo

PHOENIX DIGITAL OCM-DPR-1 - Page 48

Default Icon
60 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
DH+/RIO OPTICAL COMMUNICATION MODULES USERS MANUAL
Copyright © 2003 by Phoenix Digital Corporation, All Rights Reserved.
2-3
2.4.2 1746 OLCs AND 1756 OCXs (REFERENCE FIGURES 5 AND 6 FOR FIBER
OPTIC MODULE NOMENCLATURE AND DESIGNATIONS).
(i) Local Tx, Rx
- Illuminates flashing green when the tramsmit data output is active (transmit
data from the OLC/OCX Device Interface to the local device).
- Illuminates flashing yellow when the receive data input is active (transmit
data from the local device to the OLC/OCX Device Interface).
- Illuminates solid green when both the receive and transmit data inputs are
active (simultaneous transmit and receive data between the local device
and the OLC/OCX Device Interface).
(ii) OK... Module Without Diagnostic Option -
Illuminates continuous green when the OLC/OCX module is powered.
OK... 1746 OLC Module With Diagnostic Option -
Illuminates continuous green when the OLC module is powered.
OK... 1756 OCX Module With Diagnostic Option -
Illuminates flashing red when previously established communication
with the OCX I/O module slot has timed out.
Illuminates continuous red during reset condition.
Illuminates flashing green when the OCX I/O module slot is not
correctly configured, or is not actively controlled by a system processor.
Illuminates continuous green during normal operation.
(iii) Ch A, B AC/ER for OLC; Ch A, B ACT/ERR for OCX (Ch A, B Active/Error) -
Illuminates green when the corresponding optical network receive input is
receiving valid communications. Illuminates red when the corresponding
optical network receive input fails to detect valid communications.
(iv) Ch A, B ID/IF for OLC; Ch A, B ISD/IFD for OCX (ChA, B
Initial Signal Detect/Impending Failure Detect) - Illuminates green when the
corresponding optical network receive input is initialized for Impending Fault
Detection. Illuminates red when the corresponding optical network receive
input power level drops 3.0 decibel-milliwatts (optical) below the Initial Signal
Strength (see Section 1.3.3.7 for Initialization Procedure).