To Next PageTo Next Page
Need help?Do you have a question about the Phoenix Gold TI1600.5 and is the answer not in the manual?
Details frequency response, SNR, crossovers, and power output for front and rear channels.
Details frequency response, SNR, crossovers, and power output for the subwoofer channel.
Key overall specifications including fuse size, wire gauge, and unit dimensions.
Connects signal cables from the head unit and to speakers/subwoofers.
Selects between 2, 4, or 5 channel input configurations from the head unit.
Controls crossover points for speaker outputs, with FLAT/OFF, HP, and LP/BP modes.
Adjusts amplifier level, bass boost, subsonic, and low pass level controls.
Details 12V+, Remote, and Ground connection requirements and wiring.
Explains Peak and Protect indicators and RMD port for voltage display.
Guides through initial setup like installing fuses and setting input sensitivity.
Details fine-tuning crossover frequencies, levels, and EQ for optimal sound.
Diagnoses problems like no power, no sound, or protect LED activation.
Addresses issues like no sound from one side, low output, and frequent shutdowns.
Details the one-year limited warranty, coverage, and exclusions.
Explains warranty coverage for products purchased outside the USA.
Details frequency response, SNR, crossovers, and power output for front and rear channels.
Details frequency response, SNR, crossovers, and power output for the subwoofer channel.
Key overall specifications including fuse size, wire gauge, and unit dimensions.
Connects signal cables from the head unit and to speakers/subwoofers.
Selects between 2, 4, or 5 channel input configurations from the head unit.
Controls crossover points for speaker outputs, with FLAT/OFF, HP, and LP/BP modes.
Adjusts amplifier level, bass boost, subsonic, and low pass level controls.
Details 12V+, Remote, and Ground connection requirements and wiring.
Explains Peak and Protect indicators and RMD port for voltage display.
Guides through initial setup like installing fuses and setting input sensitivity.
Details fine-tuning crossover frequencies, levels, and EQ for optimal sound.
Diagnoses problems like no power, no sound, or protect LED activation.
Addresses issues like no sound from one side, low output, and frequent shutdowns.
Details the one-year limited warranty, coverage, and exclusions.
Explains warranty coverage for products purchased outside the USA.
General| Channels | 5 |
|---|---|
| Frequency Response | 20Hz - 20kHz |
| THD | <0.05% |
| Signal to Noise Ratio | >90dB |
| Bass Boost | 0 - 18dB |
| Input Sensitivity | 200mV - 6V |
| Bass Boost @ 45Hz | 0 - 18dB |
| Crossover Type | LP/HP/BP |
