11
DOLPHIN
Instruction Manual
INSTALLING THE MOTOR AND BATTERY
This model can fly with electric, here is our
recommended for set up the system.
- Motor brushless: Rimfire .46 - .55
- Lipo cells: 6 cells / 4000 - 5500 mAh.
- ESC: 50A - 80A.
INSTALLING THE ENGINE
1. Install the engine mount to the fuselage.
2. Locate the long piece of wire used for the throttle
pushrod. One end of the wire has been
pre-bend in to a "Z" bend at the factory. This "Z"
bend should be inserted into the throttle arm of
the engine when the engine is fitted onto the
engine mount. Fit the engine to the engine
mount using the screws provided.
34
35
33
Installing the electric motor
60mm
35mm
16mm
32
31
29
30
MAIN GEAR INSTALLATION
INSTALLING THE MAIN LANDING GEAR
1. Four nuts have been installed at the factory.
2. Install main landing gear into the fuselage using
(4) 4mm x 20mm machine screws and 16mm
flat washers provided in the kit.
Screw
Remove the covering
Screw
Screw
Screw
To Next Page
Loading...
