SERVO INSTALLATION
INSTALLING THE FUSELAGE SERVOS
1. Install the rubber grommets and brass collets
into the elevator, rudder and throttle servos.
Test fit the servos into the servo tray. Trim the
tray if necessary to fit your servos
2. Mount the servos to the tray using the mounting
screws provided with your radio system.
To carburator
To muffler
39
40
Elevator servo
Rudder servo
Throttle servo
38
Zip tie
12
DOLPHIN
Instruction Manual
36
37
ESC
Battery
FUEL TANK INSTALLATION
1. Assemble the fuel tank.
2. Slide the fuel tank in the fuselage using foam
rubber to cushion the tank, and route the fuel
lines out the hole in the firewall.
Atter confirming the direction (see
front view of fuel tank). Insert and
tighten the screw.
5mm
To Next Page
Loading...
