Maintenance
Printhead Cleaning Steps:
@Turn the printer off, remove the power cord and open the cover.
@Wait until the Printhead cools down. The Printhead may be very hot
after printing.
@Completely clean Printhead using an alcohol swap (NOTWATER).
@Wait until the alcohol has completely vaporized, then close the cover.
@Connect the power cord and print a test page to check if it is clean.
NOTICE: Ensure power is off when performing maintenance.
QI Pro Tips
> Anytime you change your label, run the automatic identification of the
label size.
>To print a test page, pressand hold the FeedButton for 2 sec,while printer is
standby.Afterthe blue light flashes 1times, then releasethe FeedButton.
> Avoid using poor quality labels as they can damage the printer.
> Regularly clean the Printhead.
> Insert Phomemo into the same USB port on your computer every time.
This will avoid creating duplicate copies of the printer in your operating system.
> If paper is jammed, turn the printer off and allow the printhead to cool
down. Open the Cover (Seethe picture q). Check for any residue on the
Printhead and Platen roller. Clean it of residue and use the alcohol pads to
clean the Printhead and Platen Roller. (Any 70% alcohol pad would work. See
the picture r) Then close the Cover securely, after it is dry. Firmly press the
Cover to confirm that it has been completely closed, then you can print.
(q)
(r)
11 —
To Next Page
Loading...
