Phomemo PM-246S - Page 8

•l Status Light Descriptions
LED Status
and Color
Solid Blue
Flashing
Blue slowly
Flashing
Blue quickly
Solid Red
FlashingRed
slowly
FlashingRed
quickly
Solid Purple
Printer status
Standby
Labeljams or label detection
error
Wrong media tracking
The Printhead is over
temperature.
Labelsare empty or not loaded
properly
The Cover has NOT been
completely closed
Printing
Troubleshooting
Turn off printer. Open the Cover and use
the alcohol pads to wipe the Printhead,
Platen Roller and Detection Sensor clean.
(Any 70% Alcohol pad would work.)
Allow 2-3 minutes for components to dry,
then close the Cover and turn Label Printer
back on.
Changethe way of automatic identification
of the label size.
(1) Forlabels that areseparatedby black
lines or marks: While printer is standby,
press and hold the Feed Button for 7 sec.
After the blue light flashes 3 times, then
release the Feed Button.
(2) Forlabels that areseparatedby gaps:
While printer is standby, press and hold the
FeedButton for 5 sec.After the blue light
flashes 2 times, then release the Feed
Button.
*Anytime you change your label, run the
automatic identification of the label size.
Printing will stop until the Printhead cools
to an acceptable printing temperature.
When it does, the printer will automatically
resume operation.
Check the label status or replace new labels
Firmly pressthe Coverto confirm that it has
been completely closed.
FlashingPurple
Pause printing
quickly
Note: It is not necessary to turn off the printer for these errors. After trouble
shooting it should continue to work.
07