ComPilot II Troubleshooting
Pairing a ComPilot II with
the TVLink II
1. Verify the ComPilot II is “on” with green ashing light
above Power.
2. Turn the TVLink II on.
3. Delete pairings on the TVLink II by doing
the following:
a. Press and hold the “P” button on the back of
the device until it starts rapidly blinking blue.
b. Continue to hold for approximately 10 seconds
until the light turns green.
c. The light will then start to rapidly blink blue.
It is now in pairing mode.
4. Press the “< >” button on the left and the “+” button
on the front of ComPilot II simultaneously and hold
them down for 2 seconds until the Audio indicator
starts to rapidly blink blue. Release as soon as you see
the rapidly blinking blue light.
5. Place the ComPilot II and TVLink II next to each other.
6. Within 2 minutes, the ComPilot II and TVLink II lights
will be solid blue.
You can now use the ComPilot II with the TVLink II.
Pairing the ComPilot II with
the RemoteMic
1. Verify the ComPilot II is “on” with green ashing light
above Power.
2. Delete the pairings on the RemoteMic by doing
the following:
a. Verify RemoteMic is “o” and not showing lights.
b. Press and hold down the volume up (+) button
at the same time as turning the RemoteMic “on.”
The green light will appear, followed by a rapidly
blinking blue light.
c. Continue to hold the volume up (+) button for
approximately 10 seconds until the light goes
back to green and then release.
d. The light will now be rapidly ashing blue. It is
now in pairing mode.
3. Press the < > button on the side and the (+) button
on the front of ComPilot II simultaneously and hold
them down for 2 seconds until the Audio indicator
starts to rapidly blink blue. Release as soon as you see
the rapidly blinking blue light.
4. Place the ComPilot II and RemoteMic next to
each other.
5. Within 2 minutes, the ComPilot II and RemoteMic
lights will be solid blue.
You can now use the ComPilot II with the RemoteMic.
To Next Page
Loading...
Need help?
General
