Phonak ComPilot Setup Guide

Phonak ComPilot and iPhone
Bluetooth pairing guide
V1.00/2011-09/rz © Phonak AG All rights reserved
1. Charge and turn on the mobile phone and ComPilot.
2. Place them next to each other.
3. Prepare ComPilot for pairing
■
Press and hold the Connect and Volume buttons simultaneously
for 2 seconds until the Audio indicator starts to rapidly blink blue.
■
Start the pairing process on the phone as described below.
■
Please consult your phone‘s user guide if you need more information.
5. End of pairing
■
After successful pairing, the ComPilot Audio indicator will stop rapid ashing blue.
■
Additionally a headset symbol may appear on the main screen of your phone.
■
After 2 minutes the ComPilot will automatically exit from pairing mode. If step 4 was not
completed before, simply start the pairing mode on ComPilot again as described in step 3.
4. Prepare the mobile phone for pairing
Find the connectivity settings of the phone. With most models, the following navigation applies.
The Bold terms might be dierent depending on the exact phone model.
■
Touch Settings > General > Bluetooth
■
Ensure Bluetooth is turned On
■
Wait until Phonak ComPilot is found
■
Select the Phonak ComPilot from the list
■
Enter the PIN code 0000 (4 zeros)
■
Touch Connect
Pairing iPhone
poweraudio
au
au
au
au
au
au
au
au
u
au
au
di
di
di
di
di
di
di
di
di
di
di
o
o
o
o
o
o
o
o
o
o
o
u
u
di
di
i
i
di
i
i
di
di
di
di
d
d
poweraudio
au
au
au
au
au
au
au
au
u
u
au
au
u
di
di
di
di
di
i
di
di
di
di
di
i
di
o
o
o
o
o
o
o
o
o
o
o
o
u
di
i
di
di
i
i
di
i
i
di
di
d
di
d
d
d
2 sec

Phonak ComPilot Specifications

General

Brand	Phonak
Model	ComPilot
Category	Hearing Aid
Language	English