33
14.1 Enter ight mode
To disable the wireless function and enter ight mode in
CROS device:
1. If the CROS device is turned o,
proceed to step 2.
If the CROS device is on, turn it o
by pressing and holding the lower
part of the button for 3 seconds,
until the indicator light turns solid
red for 3 seconds, signifying that
the CROS device is switching o.
2. Press and hold the lower part of
the button. The green indicator
light blinks when the CROS device
starts up.
3.
Keep pressing the button for
7 seconds, until the indicator light
is solid orange, then release the
button.
The solid orange light indicates the
CROS device is in ight mode.
In ight mode, your CROS system cannot connect directly
to your phone.
To Next Page
Loading...
