EasyManuals Logo

Phonak Roger Pen How To Connect

Phonak Roger Pen
2 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
How to Connect with
Roger Pen and EasyPen
General Operation
Device Description
1. On/Off/Mute
2. Connect
3. Indicator light (LED)
4. Microphone
5. Charging and audio input (micro-USB)
6. Slot for Roger Pen/EasyPen
7. Audio input (3.5mm/1/8 inch jack)
8. Charging input (micro-USB)
To switch on, press the On/Off button on the side of the Roger Pen/EasyPen for 3 seconds.
To switch off, press the press the On/Off button on the side of the Roger Pen/EasyPen for 3 seconds.
To connect, hold your Roger Pen/EasyPen close (within 10 cm/4 inches) from the
Roger receiver. Then, press the connect button on your Roger Pen/EasyPen.
When charging with the supplied USB power cord, the indicator light will shine solid green when fully charged.
2
1
3
4
5
6
8 7

Other manuals for Phonak Roger Pen

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Phonak Roger Pen and is the answer not in the manual?

Phonak Roger Pen Specifications

General IconGeneral
TypeWireless Microphone
Water ResistanceNo
ConnectivityBluetooth
Battery LifeUp to 7 hours
Charging Time3 hours
CompatibilityCompatible with Roger receivers and hearing aids
UsageSpeech enhancement in noisy environments
RangeUp to 20 meters
Microphone TypeDirectional

Related product manuals