36 37
16.2 Exit ight mode
To enable the wireless function and exit ight mode in
each hearing aid:
Switch the hearing aid o
and then on again
- refer to chapter 9.
17. Rebooting your hearing aid
Use this technique if your hearing aid is in an error state.
This will not remove or delete any program or settings.
1.
Press the button for at least 15 seconds. It does not
matter if the hearing aid is switched on or o before you
start pressing the button. There is no light or acoustic
notication at the end of the 15 seconds.
2.
Place the hearing aid in the power-connected charger
and wait until the indicator light blinks green. This can
take up to 30 seconds. The hearing aid is now ready
to use.
To Next Page
Loading...
Need help?
General
