If you selected the “Sub Harmonics” at point 9.
10.B. Input A/B SH
Sub Harmonics
-> Sub_H Byp = Off -> Sub_H Byp = Off On Same as PM2
Off :
-> Sub_H Mix = 50% 0 Same as PM2
: :
100% Same as PM2
-> Sub_H Filter = 24-36Hz 24-36Hz Same as PM2
36-56Hz Same as PM2
Output Channels Editing
By pushing and holding the 1, 2, 3, 4, 5 and 6 output channel buttons for at least 2 seconds, you can access the different parameters for
their respective output channels.
NAV/PM1 Encoder NAV/PM1 Enc. PM2 Enc. PM3 Enc.
[to navigate between menus] [to chose values for the parameters, no need to conrm the chosen values,
which are automatically loaded during the encoders use]
1. Output[x] [Name] Name
Name = [Name]
-> Name = _ (For Editing the Device's Name, refer to the Details on the“Utility Menus Use” Section)
2 Output[x] [Name] Source
Source = InA
-> Source = InA PM1 N/A. InA (Channel A) Same as PM2
InB (Channel B)
InA+InB (Channel A+ Channel B)
3. Output[x] [Name] Gain
Gain = + 0.0 dB
-> Gain = + 0.0 dB PM1 N/A -15 db Same as PM2
:
+15 dB
4. Output[x] [Name] RMS Cmp
Thr: +12.0dBu Rto: 1:1
-> Thr: +12.0dBu Rto: 1:1 PM1 N/A [Threshold] +20.0dBu [Ratio] 1:1
: :
-10.0dBu 32:1
5. Output[x] [Name] RMS Cmp
A: 5ms R: 0.2s Kn= 2%
-> A: 5ms R: 0.2s Kn= 2% [Atk time] 5ms [Rel time] 0.1s [Knee.] Hard (00%)
: : :
200ms 3.0s Soft (100%)
To Next Page
Loading...
