Need help?Do you have a question about the Phonic POWERPOD 1860 Plus and is the answer not in the manual?
General| Brand | Phonic |
|---|---|
| Model | POWERPOD 1860 Plus |
| Category | Music Mixer |
| Language | English |
Details specific features and upgrades for the K-12 Plus and K-16 Plus models.
Highlights features and upgrades unique to the 1860 Plus model.
Initial steps and precautions before powering on and connecting the mixer.
Procedure for setting audio levels for each input channel.
Description of various input jacks for microphones and instruments.
Details the TRS phone jack used for external processors and equalizers.
Explanation of RCA and 1/4" TS inputs for stereo signals.
Details connections for Tape In, Record Out, and Stereo Returns.
Switch to select between 115VAC and 230VAC power modes.
XLR port for connecting a gooseneck lamp for illumination.
Instructions for turning the device on and off safely.
Port for connecting the AC power cable.
Details professional speaker connectors and 1/4" phone jacks.
Detailed explanation of controls for gain, EQ, filters, and levels per channel.
Explanation of Peak, SIG, and PFL indicators for signal monitoring.
Details the channel on/off button and the main level fader.
Details the display, indicators, and program selection for effects.
Explains how to enable, monitor, and control the DSP effects.
Adjusts the audio level from the DSP to the main mixing bus.
Controls power amp activity and routing of signals.
Details the SPS switch and the Graphic Equalizer with feedback detection.
Explains the stand-by function and phantom power switch.
Details controls for stereo returns, tape inputs, zone outputs, and monitoring.
Controls for adjusting the output levels of auxiliary and mono signals.
Details the low pass filter for the mono output.
Explains the master fader, power light, and PFL/AFL status indicators.
Details limiter status and the stereo main output level meter.
Details power output in Watts for different impedance loads.
Lists total channels and types of input connectors available.
Details types of output connectors and signal routing.
Lists features like EQ, Pan/Balance, and Mute for each channel strip.
Details controls and indicators in the master section.
Details number of channels and segments for level metering.
Specifies the +48V DC phantom power supply.
Details the number of effects, tap delay, and test tones.
Details the stereo 7-band graphic EQ parameters.
Total Harmonic Distortion at power output.
Total Harmonic Distortion for other outputs.
Low frequency equalization setting.
Mid frequency equalization setting.
High frequency equalization setting.
Low cut filter frequency and slope.
Diagram illustrating connections for external parallel devices.
Detailed measurements for the K-12 Plus and 1860 Plus models.
Detailed measurements for the K-16 Plus model.
To Next Page