7
Name / Function of Each Part
LCD Screen
Memory Button
Start / Stop
Signal Output Port
Cuff
Installing / Replacing the Batteries
1. Slide out the battery cover.
2. Install 4 “AA” batteries, being careful to
respect the polarities (+ and -).
3. Slide back the battery cover.
• Replace all batteries if the low battery
indicator appears.
• Remove the batteries if the unit will not be
used for a long period of time.
• It is recommended to use the same type of
alkaline batteries to avoid incompatibility.
Displays
Systolic Clock
Pulse
Memory
Diastolic
Low Battery Indicator
8
The pressure measured was
lower than 20 mmHg.
Measure again quietly.
The pressure measured was
higher than 300 mmHg.
Measure again quietly.
Pumping error. Verify that the
cuff is properly applied and
measure again.
Pressure cannot be measured
due to signal noise. Measure
again.
Pumping pressure exceeds
300 mmHg. Measure again.
or no display
Low battery. Verify that the
batteries are in place and
replace them if necessary.
To Next Page
Loading...
