TROUBLESHOOTING TROUBLESHOOTING
This section includes a list of error messages and frequently asked
questions for problems you may encounter with your blood
pressure monitor. If the product is not operating as you think it
should, check here before calling customer service.
Display is dim or will not light up
1615
PROBLEM DISPLAY CAUSE SOLUTION
Batteries are low.
Incorrect . measurement
No power
Low Batteries
Error Message
The cuff is not secure.
A calibration error
occurred.
Retake the measurement.
If the problem persists,
®
contact Physio logic at:
1-800-363-2381.
The pressure of the
cuff is too high.
The monitor detected
motion while measuring.
Movement can affect the
measurement. Relax for
a moment and then
measure again.
Relax for a moment
and then measure again.
Relax for a moment
and then measure again.
Batteries are exhausted.
Replace with new batteries
Batteries are inserted
incorrectly.
Insert the batteries
correctly.
Replace with new batteries.
Refasten the cuff and
then measure again
The cuff is too tight
Refasten the cuff and
then measure again
Physio logic Prisma Manual (ENG)
106-950 n/a
10” x 7.125”
10” x 7.125” (folded: 5” x 7.125”)
Instruction Booklet
Travis Fraser
TM
X
To Next Page
Loading...