ManualCU-1A/1B/2A/2BPage 4/32
Introduction to the manual
1. Introduction to the manual
1.1 Revision history
May 2022 Rev.01 First version
1.2 About the manual
The responsible party for the production site must
ensure that this manual will be read and understood.
The section on safety should be studied extra
carefully.
The manual should be stored on a known and easily
accessible place, which can be digital.
A printed manual must accompany the product or
equipment if the location is changed.
When rebuilding or restructuring, a new risk analysis
is required.
All kinds of changes must be approved by machine
owner.
Carefully study the applicable parts of the manual
before performing service and maintenance of the
equipment.
1.3 Safety signs used in the manual
Take note of all Warning-, Mandatory and other signs
in this manual. They have the following meaning:
1.3.1 Warning signs
Warning!
Breach of this information may result in
death or serious injury!
Caution!
Breach of this information may result in
less personal injury or damage to the
machine!
Electrostatic sensitive device
The electronics are sensible to
electrostatic discharges, spare part
change should be done in an
electrostatic discharge protected area.
1.3.2 Mandatory signs
Note!
Information that needs extra attention!
1.4 Target group
This manual, especially the section about safety,
shall be read by all staff who will perform any type of
work with the product or equipment:
•
Operating personnel
•
Service and maintenance personnel
•
Cleaning staff (cleaning of equipment and the
area around it).
To Next Page
Loading...