PIAB CU-1A - Introduction to CU-1;2 A;B; Manufacturer; Intended Use; Misuse

ManualCU-1A/1B/2A/2BPage 6/32
Introduction to CU-1/2 A/B
3. Introduction to CU-1/2 A/B
3.1 Manufacturer
Piab AB
P.O. Box 146
SE-182 12 DANDERYD
SWEDEN
3.2 Intended use
The intended use of the control unit CU-
1A/1B/2A/2B is to be connected to a Piab vacuum
conveyor system.
•
The product shall be used in environments
within the product’s specifications.
•
The product shall be installed in accordance to
installation instructions.
•
The product shall be maintained in accordance
to maintenance instructions.
•
Troubleshooting shall be conducted in
accordance to manual instructions.
•
The safety instructions shall be followed.
•
For professional use only.
3.3 Misuse
The control unit CU-1A/1B/2A/2B must not be used:
•
For other use than those established by the
machine owner or reported in this manual.
•
If the product is damaged.